Configuration and Installation
Chapter 2
SCXI-1124 User Manual
2-4
© National Instruments Corporation
Notes:
Cable your DAQ board to only one module in each chassis.
For installation procedures with other SCXI accessories and boards, consult your
cable installation guide.
6. Check the installation.
7. Turn on the SCXI chassis.
8. Turn on the computer or reconnect the DAQ board to your chassis.
The SCXI-1124 module is installed. You are now ready to install and configure your software.
If you are using NI-DAQ, refer to your NI-DAQ manual. The software installation and
configuration instructions are in Chapter 1, Introduction to NI-DAQ. Find the installation and
system configuration section for your operating system and follow the instructions given there.
If you are using LabVIEW, the software installation instructions are in your LabVIEW release
notes. After you have installed LabVIEW, refer to the Configuring LabVIEW section of
Chapter 1 in your LabVIEW user manual for software configuration instructions.
If you are using LabWindows, the software installation instructions are in Part 1, Introduction to
LabWindows, of the Getting Started with LabWindows manual. After you have installed
LabWindows, refer to Chapter 1, Configuring LabWindows, of the LabWindows User Manual
for software configuration instructions.
