Chapter 9
SC-2057
9-14
©
National Instruments Corporation
Perform the following steps to install the SCXI-1348 cable adapter:
1.
Turn off the power to the VXI Chassis and the SCXI chassis.
2.
Install your SCXI module in the SCXI chassis, following the
instructions in your module user manual.
3.
Plug the front connector of the SCXI-1348 into the rear signal
connector of the SCXI module. A corner of the adapter board will enter
the upper board guide of the chassis.
4.
Secure the SCXI-1348 adapter board by screwing the two screws
through the rear panel of the adapter board and into the threaded strips
in the rear of the SCXI chassis.
5.
Connect one end of the 50-pin ribbon cable to the adapter board rear
connector.
6.
Connect the loose end of the ribbon cable to either of the 50-pin
connectors, J1 or J2, on the SC-2057.
Summary of Contents for SC-205 Series
Page 1: ...SC 2071...
