Chapter 7
SC-2055
©
National Instruments Corporation
7-3
Figure 7-2.
SC-2055 Connections
Table 7-1 describes the connectors on the SC-2055.
Table 7-1.
SC-2055 Connectors
Connectors
Connection
Description
J1, J2
50-pin male ribbon cable connectors;
DAQCard-700 or PC-LPM-16/PnP
connection
Attach J1 or J2 to the DAQ device. You can attach the other
connector to the SC-2070 or CB-50. The connections at J1 and
J2 are identical so you can daisy-chain to the DAQ device
signals.
J3
26-pin male connector; 5B Series
analog input connection
Attach J3 to the 5B Series backplane. This connection takes
analog input lines 0–15 on the DAQCard-700 or
PC-LPM-16/PnP to channels 0–15 of the 5B Series backplane,
in sequential order.
J4
26-pin male connector; 5B Series
analog I/O connection; pin 20 is
connected to channel 14 of the 5B
Series; pin 21 is connected to channel
15 of the 5B Series
Attach J4 to the 5B Series backplane. This connection takes
analog input lines 0–13 on the DAQCard-700 or
PC-LPM-16/PnP to channels 0–13 of the 5B Series backplane,
in sequential order. Pin 20 of the DAQCard-700 or
PC-LPM-16/PnP is connected to channel 14 of the 5B Series
and pin 21 is connected to channel 15.
J5
26-pin male connector; digital input
connection
Attach J5 only to the SC-2060. This connection takes the eight
digital input lines from a DAQCard-700 or PC-LPM-16/PnP to
a digital signal conditioning accessory with a compatible pin
assignment, such as the SC-2060.
J6
26-pin male connector; digital output
connection
Attach J6 to the SC-2061, SC-2062, or 8-channel SSR Series
backplane. This connects the eight digital output lines from the
DAQCard-700 or PC-LPM-16/PnP to a digital signal
conditioning accessory with a compatible pin connections.
SC-2072
or CB-50
SC-2055
DAQCard 700/
PC-LPM-16/PnP
J1
J2
SC-2061, SC-2062
SSR Series backplane
5B Series
5B Series
5B Series
J3 Analog Input
J4 Analog I/O
J5 Digital Input
J6 Digital Output
Summary of Contents for SC-2042-RTD
Page 1: ...SC 2042 RTD...
