©
National Instruments Corporation
11
NI RMC-8354 Installation Guide
Note
One pair of short brackets includes screw threads, and the other two pairs have slots.
If the short brackets are required for your specific rack mounting configuration, use the
pair(s) that fits into your rack best.
Note
Rack mounting hardware provided in the accessory kit, but not specifically
described in the following instructions, is for other possible rack mounting configurations
not mentioned in this manual. Consult any relevant literature provided with the intended
rack for specific mounting information before attempting to install the RMC-8354.
Installing the Inner Slides
Follow these steps to install the inner slides to the RMC-8354:
1.
Locate the right inner slide (the slide used on the right side of the
chassis when facing the chassis front panel).
2.
Align the four square holes on the right inner slide against the hooks
on the right side of the chassis, as shown in Figure 2.
3.
Securely attach the slide to the chassis with two M4 flathead screws.
4.
Repeat steps 1–3 to install the left inner slide to the left side of the
chassis.
Figure 2.
Installing Inner Slides
1
Hooks on Chassis
2
Square Holes on Right Inner Slide
3
Holes for M4 Screws
1
3
2
