Verifying Hardware Installation for Remote
Targets
You can verify that the system recognizes the NI PXIe-7822R by using Measurement &
Automation Explorer (MAX).
1.
Launch MAX on the host computer.
2.
Expand
Remote Targets
in the configuration tree and locate your system.
3.
Install LabVIEW Real-Time Module 2014 SP1 and NI RIO Device Drivers February
2015 or later on your
Remote Target
.
a)
Refer to the
Installing Software on the Host Computer
section for information about
installing software on the host.
b)
Refer to the
PXI Express Controllers User Manual
at
ni.com/manuals
for
information on installing software on the target.
4.
Under
Remote Targets
, find and expand
Devices and Interfaces
.
If the device does not appear, press <F5> to refresh the view in MAX. If the device does
not appear after refreshing the view, visit
ni.com/support
for troubleshooting
information.
Connecting the NI PXIe-7822R
NI recommends using the following cables and accessories with the NI PXIe-7822R:
•
EMI suppression ferrites (777297-01)
•
Shielded 68-Pin Connector Block for R Series DIO & HSDIO Products (782914-01)
•
Shielded R Series High Speed Digital Cable, 1m (156166-01)
•
Shielded R Series High Speed Digital Cable, 2m (156166-02)
Note
NI is not liable for connections that exceed any of the maximum ratings of
input or output signals on the NI PXIe-7822R and on the computer chassis. Refer to
the
NI PXIe-7822R Specifications
, available at
ni.com/manuals
for the maximum
input and output ratings for each signal.
6
|
ni.com
|
NI PXIe-7822R Getting Started Guide
