in the fixed installation, and stationary motors with permanent connections to fixed
installations.
•
Measurement Category IV is for measurements performed at the primary electrical
supply installation, typically outside buildings. Examples include electricity meters and
measurements on primary overcurrent protection devices and on ripple control units.
Installing and Configuring
This chapter describes how to install the PXIe-6674 hardware and software and how to
configure the device.
Installing the Software
Refer to the
readme.htm
file that accompanies the NI-Sync software for software installation
directions.
Installing the Hardware
The following are general installation instructions. Consult the chassis user manual or
technical reference manual for specific instructions and warnings about installing new
modules.
1.
Power off and unplug the chassis.
2.
Locate the desired slot in your PXI Express chassis. The PXIe-6674 can be placed in any
PXI Express slot, as indicated by the glyph in
on page 5
Figure 1. PXI Express Slot Indicator Glyph
3.
Remove the filler panel for the selected slot, if applicable.
4.
Ground yourself using a grounding strap or by touching a grounded object. Follow the
ESD protection precautions described in the
.
5.
Carefully insert the PXIe-6674 into the slot, making sure to not scrape the module on any
adjacent modules. Use the injector/ejector handle to fully insert the module into the
chassis.
6.
Screw the front panel of the device to the front panel mounting rail of the chassis.
7.
If adjacent slots are not populated, use EMC filler panels to cover the opening.
Caution
To ensure the specified EMC performance, you must install PXI
EMC filler panels, National Instruments part number 778700-01, in all open
chassis slots.
8.
Visually verify the installation. Ensure that the module is fully inserted into the slot.
9.
Plug in and power on the chassis.
The PXIe-6674 is now installed.
PXIe-6674 User Manual
|
© National Instruments
|
5
