4
|
ni.com
|
NI PXIe-4610 Power Amplifier Getting Started Guide
8.
Hold the injector/ejector handle down as you slowly slide the module into the chassis until
the handle catches on the injector/ejector rail, as shown in Figure 1.
Figure 1.
Sliding the NI PXIe-4610 into the Chassis
9.
Raise the injector/ejector handle to latch the module into the chassis. The front panel of the
NI PXIe-4610 should be even with the front panel of the chassis.
10. Tighten the two front panel mounting screws to 0.31 N · m (2.7 lb · in.) on the top and
bottom of the module front panel to secure the NI PXIe-4610 to the chassis.
11. Power on the chassis.
Configure the Hardware in MAX
Use Measurement & Automation Explorer (MAX) to configure your National Instruments
hardware. MAX informs other programs about which devices reside in the system and how they
are configured. MAX is automatically installed with NI-DAQmx.
1.
Launch MAX.
2.
In the Configuration pane, expand
Devices and Interfaces
to see a the list of installed
devices. Installed devices appear under the name of their associated chassis.
3.
Expand your
Chassis
tree item.
Note
MAX lists all devices installed in the chassis. Your default device names may
vary.
4.
Record the device identifier MAX assigns to the hardware. Use this identifier when
programming the NI PXIe-4610.
1
PXI Express Chassis
2
NI PXIe-4610 Module
3
Injector/Ejector Handle in Down Position
2
3
1