4
|
ni.com
|
NI PXIe-4339 and RM-4339 User Guide and Terminal Block Specifications
Installation
Install the Software
Note
You must be an administrator to install NI software and devices on your
computer.
Ensure that the following software is installed before installing the SC Express hardware:
1.
Your application software, such as LabVIEW, LabWindows
™
/CVI
™
or .NET.
2.
NI-DAQmx—NI PXIe-4339 modules were first supported in NI-DAQmx 14.2. RM-4339
terminal blocks were first supported in NI-DAQmx 14.5.
Note
For detailed NI software version support, refer to the
NI-DAQmx Readme
.
Back up any applications before upgrading software or modifying the application.
Unpack and Install the Module
Remove the packaging and inspect the module. Contact NI if the module is damaged. Do not
install a damaged module.
Caution
The module is static sensitive. Always properly ground yourself and the
equipment when handling or connecting to the module.
Complete the following steps to install the NI SC Express module while referring to Figures 1
and 2:
Note
To maintain forced air cooling in the PXIe system, refer to the
Maintain
Forced-Air Cooling
document.
1.
Make sure the chassis is powered off.
2.
Connect the power cord to your chassis and then plug it into the power supply receptacle
before installing the NI PXIe-4339. The power cord grounds the chassis and protects it
from electrical damage while you install the module.
Caution
To protect yourself, the chassis, and the NI PXIe-4339 from electrical
hazards, leave the chassis powered off until you complete the NI PXIe-4339 module
installation.
