Chapter 2
Installation and Configuration
©
National Instruments Corporation
2-7
3.
When you begin to feel resistance, pull up on the injector/ejector
handle to inject the controller fully into the chassis frame. Secure the
controller front panel to the chassis using the four controller
front-panel mounting thumbscrews.
4.
Connect the keyboard, mouse, and monitor to the appropriate
connectors. Connect devices to ports as required by your system
configuration.
5.
Power on the chassis. Verify that the controller boots. If the controller
does not boot, refer to the controller user manual.
Figure 2-3 shows a PXI controller installed in the system controller slot of
a PXI-1052 chassis. You can place CompactPCI or PXI modules in any
other slots.
Figure 2-3.
NI PXI Controller Installed in a PXI-1052 Chassis
1
PXI-1052 Chassis
2
Injector/Ejector Rail
3
NI PXI Controller
3
1
2
NI PXI-1052
