Chapter 2
Installation and Configuration
2-18
ni.com
5.
Set the network configuration options of the RT target in the
IP Settings
section and click the
Apply
button.
For information about configuring network settings, refer to the
Configuring Network Settings
book, accessible by browsing to
MAX Remote Systems Help»LabVIEW Real-Time Target
Configuration»Configuring Network Settings
from the
Contents
tab of
MAX Help
.
Note
When any IP or identification settings are changed, you will be prompted to reboot
the controller for the changes to take effect. Click
Yes
to automatically reboot the
RT target. You may also reboot the controller by right-clicking on the target name under
Remote Systems
and selecting
Reboot
.
After rebooting the PXI controller it will appear in the
Remote Systems
category with the assigned name.
Figure 2-4 shows the RT Series PXI target,
PXI-8110
, configured to
automatically obtain an IP address from a DHCP server, as indicated in the
IP Settings
section of the figure.
Figure 2-4.
Configuring RT Target Network Settings
