Chapter 2
Installation and Configuration
2-14
ni.com
Figure 2-3.
Clearing the CMOS Contents
LabVIEW RT Configuration Switches
Use the LabVIEW RT configuration switches to configure LabVIEW RT
if it is installed on the controller. If you are not using LabVIEW RT, these
switches should remain in the OFF position. The controller reads these
switches only after a system reset. You must reboot the controller for any
changes to take place.
The NI PXI-8106 controller includes the following LabVIEW RT
configuration switches:
•
Switch 1—Boot LabVIEW RT
: Set this switch to ON to boot
LabVIEW RT.
1
Normal Operation (Default)
2
Clear CMOS Contents
3
Pin 1
1
2
3
