D-2
|
ni.com
Appendix D
PCI-8366 Low-Profile Bracket Installation Instructions
5.
Remove the standard height bracket as shown in Figure D-2.
Figure D-2.
Removing Bracket
6.
Fit the low-profile bracket onto the PCI-8366 by aligning the square cutout on the bracket
with the SFP receptacle on the card. Ensure the two mounting tabs on the low-profile
bracket rest against the back side of the card. The mounting holes are aligned with the
threaded holes on the mounting tabs of the bracket, and the LED bulb is situated in the
bracket display hole correctly.
7.
Install the two Phillips screws from the front side of the card. Tighten each screw to a
maximum torque of 3.6 lb · in. (0.407 N · m).
8.
Hold the SFP module in the orientation shown in Figure D-1. Ensure the release lever is
closed in its upright position and gently slide the SFP module into the SFP receptacle. The
SFP module will click into place when fully engaged, as shown in Figure D-3.
Figure D-3.
Completed Low-Profile Bracket Installation on the PCI-8366
1
Standard Height Bracket
2
4-40 ×1/4 inch Phillips Head Screws (x2)
3
Front Side of Card
4
Mounting Tab
3
4
1
2
