nuDrive Accessory User Guide
12
www.ni.com
Figure 9.
Pin Assignment for the Active Limit Switch Terminal Block on the
CX and SX nuDrives
CF nuDrive Configuration
On CF nuDrives, the per-axis High-Speed Capture input signal is available
on pin 4 of each limit switch terminal block. Pin 5 provides an External
Inhibit input signal for remotely inhibiting the nuDrive axis. All limit
signals are filtered in the nuDrive and debounced by the FlexMotion-6C
controller to reduce noise sensitivity. The CF nuDrives and FlexMotion-6C
controllers provide for optically isolated limit switch inputs, and pin 6 is the
isolated (ISO) Common signal connection. Refer to Figure 10 for the CF
nuDrive terminal block pin assignments.
Figure 10.
Pin Assignment for the Limit Switch Terminal Block on the
CF nuDrive
The Limit, High-Speed Capture, and External Inhibit signals are
opto-coupled inputs and require a voltage source. You can either use an
external isolated voltage source, or you can use the +5 V and ground signals
on the host computer by properly setting a jumper to connect the isolated
voltage (input) to 5 V and the ISO Common signal on the FlexMotion-6C
board. Refer to the FlexMotion-6C Hardware User Manual for more
information. Refer to the
section of this guide for more
information on the FlexMotion-6C isolated input connection.
1
2
3
4
5
6
CW Limit
Home Switch
Common
CCW Limit
+12
Out
GND
+12
Out
GND
+12
Out
GND
+12 VDC
+5 VDC
1
2
3
4
5
CW Limit
Home Switch
CCW Limit
High-Speed Capture
External Inhibit
ISO Common
6
Summary of Contents for nuDrive 2CF-001
Page 32: ......
