Chapter 2
Setup and Configuration
NI CVS-1450 Series User Manual
2-16
ni.com
Installing the LabVIEW Real-Time Module, Vision Development
Module, and NI-IMAQ for IEEE 1394 Cameras
Note
You must install LabVIEW, the LabVIEW Real-Time Module, and the Vision
Development Module software
before
installing the NI-IMAQ for IEEE 1394 Cameras
driver software.
Complete the following steps to install LabVIEW, the LabVIEW
Real-Time Module, the Vision Development Module, and NI-IMAQ for
IEEE 1394 Cameras onto the development computer.
1.
Insert the LabVIEW CD into the CD-ROM drive.
2.
When the installation splash screen appears, click
Install LabVIEW
,
and follow the setup instructions.
3.
Insert the LabVIEW Real-Time Module CD into the CD-ROM drive.
4.
When the installation splash screen appears, click
Install LabVIEW
Real-Time Module
, and follow the setup instructions.
5.
Insert the Vision Development Module CD into the CD-ROM drive.
6.
When the splash screen appears, click
Install Vision Development
Module
, and follow the setup instructions.
7.
Insert the NI-IMAQ for IEEE 1394 Cameras CD into the CD-ROM
drive.
Note
If you select the custom software installation, make sure to install the support for the
CVS-1450 Series.
8.
When the splash screen appears, click
Install
NI-IMAQ for
IEEE 1394 Cameras
, and follow the setup instructions.
9.
When prompted, click
Yes
to restart the development computer.
Configuring the IP Address using the LabVIEW Real-Time Module
To set up an IP address for the CVS-1450 device, complete the following
steps:
1.
Open the Measurement & Automation Explorer (MAX) configuration
software by double-clicking the MAX icon on the desktop, or navigate
to MAX by selecting
Start»Programs»National Instruments»
Measurement & Automation
.
2.
Expand the
Remote Systems
branch of the configuration tree, and
click
192.168.10.12
to display the Network Settings window.
This IP address is assigned to all unconfigured CVS-1450 devices.
