© National Instruments
|
1-3
on the 15-pin D-SUB connector for I/O, refer to the
section of
Chapter 3,
, for information and pin descriptions.
Caution
Use the smart camera only with a 24 VDC, UL listed, limited power
source (LPS) supply. The power supply will bear the UL listed mark, LPS. The power
supply must also meet any safety and compliance requirements for the country of use.
NI Desktop Power Supply
Refer to Figure 1-2 while completing the following steps to connect the NI desktop power
supply to the NI Smart Camera with no additional I/O.
Figure 1-2.
NI 17xx Smart Camera
1.
Connect and secure the 15-pin D-SUB connector on the NI desktop power supply to the
POWER-I/O connector on the smart camera.
2.
Plug the power supply power cord into the power supply.
3.
Plug the power supply into an outlet.
When power is first applied to the smart camera, the POWER LED flashes red for one second
while internal systems power up. The POWER LED then lights green when power is correctly
wired to the smart camera.
Third-Party Power Supply
National Instruments provides the following two cable options for connecting a third-party
power supply to the NI Smart Camera.
•
Terminal block with a 15-pin D-SUB connector, such as the NI Smart Camera I/O
Accessory, and a 15-pin D-SUB to 15-pin D-SUB cable
•
15-pin D-SUB pigtail cable
1
NI Smart Camera
2
Power Supply
2
1
Summary of Contents for NI Vision 17 Series
Page 1: ...ISC 1752...
