NI VB-8012 Safety, Environmental, and Regulatory Information
|
© National Instruments
|
3
Connecting to the VB-8012
Connecting to the Mixed Signal Oscilloscope
Caution
Exceeding the maximum input voltage ratings, which are listed in the
NI VirtualBench VB-8012 Specifications
document, can damage
the device and the computer. National Instruments is not liable for any damage resulting from such signal connections.
Connecting to the Function Generator (FGEN)
The FGEN BNC connector is the analog waveform output terminal from which standard functions and arbitrary waveforms are generated. The maximum output
levels from this connector depend on the type of load termination.
Caution
Exceeding the maximum output ratings, which are listed in the
NI VirtualBench VB-8012 Specifications
document, can damage the
device and the computer. National Instruments is not liable for any damage resulting from such signal connections.
Connecting to the External Trigger (TRIG)
Caution
Exceeding the maximum input voltage ratings or maximum output ratings, which are listed in the
NI VirtualBench VB-8012
Specifications
document, can damage the device and the computer. National Instruments is not liable for any damage resulting from such signal
connections.
Connecting to the Digital I/O
Caution
Exceeding the maximum input voltage ratings or maximum output ratings, which are listed in the
NI VirtualBench VB-8012
Specifications
document, can damage the device and the computer. National Instruments is not liable for any damage resulting from such signal
connections.
Caution
Never connect the +3.3 V power terminal to analog or digital ground or to any other voltage source on VirtualBench or any other device.
Doing so can damage the device and the computer. NI is not liable for damage resulting from such a connection.
Digital I/O
Screw terminal wiring .............................................0.1 to 2.0 mm
2
(30 to 14 AWG)
Torque......................................................................0.25 N · m (2.2 lb · in.)
Connecting to the DC Power Supply
Caution
Exceeding the maximum output ratings, which are listed in the
NI VirtualBench VB-8012 Specifications
document, can damage the
device and the computer. National Instruments is not liable for any damage resulting from such signal connections.
Caution
Do not exceed 60 VDC from any terminal to ground when cascading power supplies.
Caution
The NI VB-8012 DC power supply does not provide isolation when using the +6 V channel.
Note
Always use twisted pair wire for connections to the DC power supply.
DC power supply
Screw terminal wiring .............................................0.1 to 2.0 mm
2
(30 to 14 AWG)
Torque......................................................................0.25 N · m (2.2 lb · in.)
Connecting to the Digital Multimeter (DMM)
Caution
Exceeding the maximum input voltage ratings, which are listed in the
NI VirtualBench VB-8012 Specifications
document, can damage
the device and the computer. National Instruments is not liable for any damage resulting from such signal connections.
Where to Go Next
The following documents contain information that you may find helpful as you use this document:
•
The
NI VirtualBench Quick Start
, packaged with your NI VirtualBench all-in-one instrument, describes how to install and configure NI VirtualBench and
confirm it is operating properly.
•
The
NI VirtualBench Help
, which can be launched from NI VirtualBench software by clicking the
?
icon, contains complete information about using your
VirtualBench hardware and application.
•
The
NI VirtualBench VB-8012 Specifications
, found on
ni.com/manuals
, lists the specifications for your VirtualBench.
