Furthermore, any changes or modifications to the product not expressly approved by National Instruments could void your authority to operate it under your
local regulatory rules.
Notice
To ensure the specified EMC performance, operate this product only with shielded cables and accessories. Do not use unshielded cables or
accessories unless they are installed in a shielded enclosure with properly designed and shielded input/output ports and connected to the product using a
shielded cable. If unshielded cables or accessories are not properly installed and shielded, the EMC specifications for the product are no longer
guaranteed.
Physical Characteristics
Weight (unloaded)
412 g (14.53 oz)
Dimensions
3U, one-slot, PXI Express/CompactPCI Express module; 2.0 cm × 13.0 cm ×
21.6 cm (0.8 in. × 5.1 in. × 8.5 in.), nominal
Maintenance
Clean the hardware with a soft, nonmetallic brush. Make sure that the hardware is completely dry and free from contaminants before returning it to service.
Environmental
This product was tested in accordance with:
• IEC 60068-2-1
• IEC 60068-2-2
• IEC 60068-2-56
Temperature
Operating
0 °C to 55 °C
Operating humidity
10% to 70%, noncondensing. Derate 1.3% per °C above 40 °C.
Storage humidity
5% to 95%, noncondensing.
Pollution Degree
2
Maximum altitude
2,000 m (800 mbar) (at 25 °C ambient temperature)
Indoor use only.
Safety Standards
This product is designed to meet the requirements of the following electrical equipment safety standards for measurement, control, and laboratory use:
• IEC 61010-1, EN 61010-1
• UL 61010-1, CSA C22.2 No. 61010-1
Electromagnetic Compatibility
This product meets the requirements of the following EMC standards for electrical equipment for measurement, control, and laboratory use:
• EN 61326-1 (IEC 61326-1): Class A emissions; Basic immunity
• EN 55011 (CISPR 11): Group 1, Class A emissions
• AS/NZS CISPR 11: Group 1, Class A emissions
• FCC 47 CFR Part 15B: Class A emissions
• ICES-001: Class A emissions
Note
In the United States (per FCC 47 CFR), Class A equipment is intended for use in commercial, light-industrial, and heavy-industrial locations. In
Europe, Canada, Australia, and New Zealand (per CISPR 11), Class A equipment is intended for use only in heavy-industrial locations.
Note
Group 1 equipment (per CISPR 11) is any industrial, scientific, or medical equipment that does not intentionally generate radio frequency
energy for the treatment of material or inspection/analysis purposes.
Note
For EMC declarations and certifications, refer to the
section.
CE Compliance
This product meets the essential requirements of applicable European Directives, as follows:
• 2014/35/EU; Low-Voltage Directive (safety)
• 2014/30/EU; Electromagnetic Compatibility Directive (EMC)
2
|
ni.com
|
PXIe-4143 Safety, Environmental, and Regulatory Information
