![background image](http://html1.mh-extra.com/html/national-instruments/ni-pxi-7851/ni-pxi-7851_user-manual_3529034019.webp)
Chapter 1
Introduction
R Series Intelligent DAQ User Manual
1-8
ni.com
Cables and Accessories
National Instruments offers a variety of products you can use with R Series
devices, including cables, connector blocks, and other accessories,
as shown in Table 1-3.
Refer to Appendix A,
, for more information
about using these cables and accessories to connect I/O signals to the
NI 78
xx
R. Refer to
ni.com/products
or contact the sales office nearest
to you for the most current cabling options.
Table 1-3.
R Series Connectivity Options
Cable
Connector
Accessory
Description
SHC68-68-RMIO
*
(NI Recommended)
0
NI SCB-68
High-performance shielded cable wired
specifically for signal connection from
the RMIO connector
†
to the NI SCB-68
terminal block to provide higher signal
integrity and noise immunity.
SHC68-68-RDIO
(NI Recommended)
1, 2
NI SCB-68
High-performance shielded cable wired
specifically for signal connection from the
RDIO connector
†
to the NI SCB-68
terminal block to provide higher signal
integrity and noise immunity.
SH68-C68-S
0, 1, 2
NI SCB-68
Basic shielded cable for signal connection
from the RMIO or RDIO connector to the
NI SCB-68 terminal block for noise
reduction.
CAT 5 Ethernet
crossover cable
*
—
—
For use with the NI PXI-78
xx
R running
the LabVIEW Real-Time Module, if the
real-time PXI system is not configured on
a network. To connect the PXI system to
a network port, use a standard CAT 5
10/100Base-T Ethernet cable.
*
NI 783
x
R/784
x
R/785
x
R devices only.
†
For a diagram of the twisted pairs in the SHC68-68-RMIO and SHC68-68-RDIO cables and the signals to which they
correspond, go to
ni.com/info
and enter the info code
rdrmio
.
Summary of Contents for NI PXI-7851
Page 1: ...PXI 7851...