NI PXI-2585/2586 Connector and Backshell Kit
4
ni.com
8.
Route all the conductors through the backshell as illustrated in
Figure 2.
Figure 2.
Backshell with Threaded Wires
9.
Refer to the front panel pinout diagram in your module specifications.
Use this diagram to insert the solder cup pins (with conductors
attached) into the connector. Solder cup pins will snap into place when
inserted correctly, as shown in Figure 3.
Note
The letters on the backshell connector match the letters on the module. For example,
connector position “A” on your PXI-2585/2586 switch module will mate with the
connector in position “A” on the backshell kit.
Note
Take care to insert the pin into the correct connector position. Once the pin is
inserted, it can only be removed from the connector with an extraction tool. Extraction
tools must be purchased separately.
1
16 AWG Stranded Wire
(UL Style 2464 Cable Shown)
2
Solder Cup Pins
2
1
