NI 9930 Motion Control Accessories User Guide
12
ni.com
16. Click
OK
to close the
Axis Manager
dialog box. The new axis is added to the
Project Explorer
window.
Note
You cannot associate more than one axis with the same C Series module.
When you have finished these steps your LabVIEW project should look similar to the image in
Figure 8.
Figure 8.
Project Explorer Window with Modules in Scan Interface Mode
Step 3: Configure the NI 9512 C Series Module
Complete the following steps to configure the axis I/O settings for use with the Mitsubishi MR-J2 or
MR-J3 servo drive.
1.
Right-click the axis in the
Project Explorer
window and select
Properties
from the shortcut menu
to open the
Axis Configuration
dialog box.
Summary of Contents for NI 9930
Page 1: ...cRIO 9014...