![background image](http://html1.mh-extra.com/html/national-instruments/ni-6584r/ni-6584r_user-manual-and-specifications_3422584011.webp)
NI 6584R User Guide and Specifications
10
ni.com
Creating an FPGA Target VI
1.
In the
Project Explorer
window, right-click
My Computer
and select
New»Targets and
Devices
.
2.
In the
Add Targets and Devices on My Computer
window, select the
Existing Target or Device
radio button and expand the FPGA Target. The target is displayed.
3.
Select your device and click
OK
. The target and target properties are loaded into the project tree.
4.
In the
Project Explorer
window, right-click the FPGA target and select
New»VI
. A blank VI
opens.
5.
Select Window
Show»Block Diagram
to open the block diagram window.
6.
In the
Project Explorer
window, select
FPGA Target (RIO
x
, PXI-79
xx
R)
.
7.
Right-click
IO Module
and select
Properties
. In the General category, you can see the available
component-level IP (CLIP) for the NI 6584 in the Component Level IP pane. If the category
information is dimmed, select the
Enable IO Module
checkbox.
Note
For more information about CLIP for the NI 6584, refer to the
section of this document.
8.
Select
NI 6584 Full-Duplex
to configure the software for the full duplex version of the NI 6584R.
9.
Select
NI 6584 Basic Connector
to use the connector-based CLIP. Click
OK
.
10. In the
Project Explorer
window, select
IO Module (NI 6584 Full-Duplex : NI 6584 Basic
Connector)
.
11. Select
RX
,
TX
, and
TX_Enable
and drag them onto the block diagram.
12. Add a While Loop around the three Data nodes.
13. Wire an indicator from the output of the
IO Module\RX
.
14. Wire a control to the input of the
IO Module\TX
.
15. Wire a numeric constant to the input of the
IO Module\TX_Enable
node. Set the value to 65,535.
(This enables all 16 TX channels like
0xFFFF
in hexadecimal.)
16. Wire a False constant to the stop condition of the While Loop.
Your block diagram should now resemble the block diagram in Figure 6.
Figure 6.
Data RW (FPGA).vi Block Diagram
17. Save the VI as
Data RW (FPGA).vi
.
18. Close the VI.
19. In the Project Explorer window under
My Computer
, expand the tree view for your device,
right-click
Data RW (FPGA).vi
and select
Compile
to compile the files for your target.
Summary of Contents for NI 6584R
Page 1: ...NI 6584 ...