![background image](http://html1.mh-extra.com/html/national-instruments/network-adapter-ni-pxie-6672/network-adapter-ni-pxie-6672_user-manual_709210027.webp)
Chapter 3
Hardware Overview
3-14
ni.com
Refer to the
section for more information on
the synchronization clock.
Note
The PFI synchronization clock is the same for all routing operations in which
PFI <0..5> is defined as the output, although the divide-down ratio for this clock (full rate,
first divider, second divider) may be chosen on a per route basis.
Using the PXI Triggers
The PXI triggers go to all the slots in the chassis. All modules receive the
same PXI triggers, so PXI trigger 0 is the same for Slot 2 as it is for Slot 3,
and so on. This feature makes the PXI triggers convenient in situations
where you want, for instance, to start an acquisition on several devices at
the same time because all modules will receive the same trigger.
The frequency on the PXI triggers should not exceed 20 MHz to preserve
signal integrity. The signals do not reach each slot at precisely the same
time. A difference of several nanoseconds between slots can occur in an
eight-slot chassis. However, this delay is not a problem for many
applications. You can route signals to the PXI triggers from PFI <0..5>,
from the PXI star triggers, or from other PXI triggers. You also can route
PXI_CLK10 or the DDS clock to a PXI trigger line (PXI_TRIG <0..7>)
using the synchronization clock.
You can independently select the output signal source for each PXI trigger
line from one of the following sources:
•
PFI <0..5>
•
Another PXI trigger <0..7> (PXI_TRIG <0..7>)
•
PXI_STAR <0..16>
•
Global software trigger
•
PXI_Trig/PXI_Star synchronization clock
The PXI_Trig/PXI_Star synchronization clock may be any of the following
signals:
•
DDS clock
•
PXI_CLK10
•
PFI 0 Input
•
Any of the previously listed signals divided by the first frequency
divider (2
n
, up to 512)
•
Any of the previously listed signals divided by the second frequency
divider (2
m
, up to 512)