![background image](http://html1.mh-extra.com/html/national-instruments/network-adapter-ni-pxie-6672/network-adapter-ni-pxie-6672_user-manual_709210012.webp)
©
National Instruments Corporation
2-1
2
Installing and Configuring
This chapter describes how to install the NI PXIe-6672 hardware and
software and how to configure the device.
Installing the Software
Refer to the
readme.htm
file that accompanies the
NI-Sync
CD for
software installation directions.
Note
Be sure to install the driver software
before
installing the NI PXIe-6672 hardware.
Installing the Hardware
The following are general installation instructions. Consult the chassis
user manual or technical reference manual for specific instructions and
warnings about installing new modules.
1.
Power off and unplug the chassis.
2.
Locate the System Timing Slot in your chassis. It is marked by either
a square glyph shown in Figure 2-1, or a square glyph with a circle
inside of it, as shown in Figure 2-2.
Figure 2-1.
System Timing Device Slot Indicator Glyph without Circle
Figure 2-2.
System Timing Device Slot Indicator Glyph on the NI PXIe-1062Q Chassis