![background image](http://html1.mh-extra.com/html/national-instruments/isc-1780/isc-1780_user-manual_3398910013.webp)
Connecting to Lighting Devices
The Power and I/O connector has a specialized analog dimmer output intended to be used with
the Advanced Illumination Inline Control System 3 (ICS 3) or ICS 3S for continuous or
strobed lighting operations.
Related Information
on page 20
on page 21
on page 3
Wiring a Lighting Device for Continuous Mode
The following figure shows how to wire the ISC-178x and an Advanced Illumination ICS 3
lighting controller without a trigger. Use this configuration to run a light in continuous mode.
Figure 9.
Wiring a Lighting Controller Without a Trigger
24 VDC
Supply
ICS 3 Lighting
Device
ISC-178x
Trigger
+
–
Analog Out
Analog
C
+
–
Wiring a Lighting Device for Strobe Mode
The following figure shows how to wire the ISC-178x and an Advanced Illumination ISC 3
lighting controller using an isolated output as a trigger. Use this configuration to run a light in
strobe mode. This configuration requires that the isolated outputs and system power share the
same ground.
12
|
ni.com
|
ISC-178x User Manual
Summary of Contents for ISC-1780
Page 1: ...ISC 1780...