IMAQ D6826 Breakout Cable
2
ni.com
Installation
Complete the following steps to connect the IMAQ D6826 breakout cable
to the IMAQ 1428 device and camera. Refer to Figure 1 for an illustration
of the cable.
1.
Connect the 68-pin VHDCI connector to the connector on the
IMAQ 1428 device and tighten the thumbscrews.
2.
For Medium configuration, connect the MDR 26-pin Camera Link
connector to a standard Camera Link cable and tighten the
thumbscrews.
3.
For Medium configuration, connect the Camera Link cable to the
Medium configuration connector of the camera.
4.
For triggering, connect the 25-pin D-SUB connector to your
application’s timing and triggering devices.
Figure 1.
IMAQ D6826 Breakout Cable
Note
If your application uses Base configuration only, you will not use the MDR 26-pin
connector.
1
68-pin VHCDCI Connector
2
MDR 26-Pin Camera Link Connector
3
Camera Link Cable
4
25-pin D-SUB Connector
2
4
1
NA
TIO
NAL
INSTRUMENTS
3
