©
National Instruments Corporation
5
NI FlexRIO FPGA Module Installation Guide
Note
If you are not using an adapter module, skip step 5.
5.
NI FlexRIO Adapter Module Support
—Refer to the
NI FlexRIO Adapter Module
Support Readme
on the NI FlexRIO Adapter Module Support installation media for system
requirements and installation instructions.
The LabVIEW documents are available from
ni.com/manuals
. You can also view the
LabVIEW Manuals directory that contains these documents by selecting
Start»All Programs»
National Instruments»LabVIEW»LabVIEW Manuals
.
Step 2. Install the NI FlexRIO devices
This section describes how to unpack and install the NI FlexRIO FPGA module and the
NI FlexRIO adapter module.
Note
You must install the software before installing the hardware. For software
installation information, refer to
Step 1. Install the Application Software and Driver
Unpacking
The NI FlexRIO FPGA module and the NI FlexRIO adapter module are shipped in antistatic
packages to prevent electrostatic discharge from damaging device components. To prevent such
damage when handling the device, take the following precautions:
•
Ground yourself using a grounding strap or by holding a grounded object, such as your
computer chassis.
•
Touch the antistatic package to a metal part of the computer chassis before removing the
device from the package.
Caution
Never
touch the exposed pins of connectors.
Remove the device from the package and inspect the devices for loose components or any other
sign of damage. Notify NI if the device appears damaged in any way. Do
not
install a damaged
device into the chassis.
Store the NI FlexRIO FPGA module and NI FlexRIO adapter module in the antistatic envelopes
when not in use.
Summary of Contents for FlexRIO PXIe-79 R Series
Page 1: ...PXIe 7975...
