![background image](http://html2.mh-extra.com/html/national-instruments/fieldpoint-fp-1001/fieldpoint-fp-1001_user-manual_3421501022.webp)
Chapter 2
Hardware Installation and Configuration
2-12
ni.com
Configuring the FP-1000/1001
Figure 2-15 shows the 8-position switch on the FP-1000/1001 network
module. Switches 1–5 set the network address, and switches 6–8 set the
baud rate.
Figure 2-15.
Address and Baud Rate Switch
The FP-1000/1001 is preconfigured for network address 0 and a baud rate
of 115.2 kbps. If you are connecting only a single network module, you do
not need to change the network address from the preconfigured setting of
address 0. You should not need to change the baud rate setting unless
you are experiencing communication problems.
Follow these steps if you need to change the address and baud rate for your
FP-1000/1001 network module.
1.
Choose and set a network address. Refer to the following section,
, for more information.
2.
Choose and set the baud rate. For more information, refer to the
section, later in this chapter.
3.
Write your address and baud rate settings in the space provided on the
FP-1000/1001 label.
4.
Apply (or cycle) power to the bank, to enable the FP-1000/1001 for the
new network address and baud rate.
5.
Make the same address and baud rate changes in your FieldPoint
software. Refer to Step 4 in the
Getting Started with FieldPoint
section of Chapter 4,
Installing and Using the FieldPoint
, for more information.
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Address
Baud
Rate
Switch Cover
(Removed)