©
National Instruments Corporation
3
ExpressCard Strain-Relief Assembly Installation Guide
To secure both an ExpressCard and ExpressCard cable, refer to Figure 2
and follow these steps:
1.
Install an ExpressCard in the controller ExpressCard slot.
2.
Using the provided hex key, loosely attach the security bracket and
sliding bracket to the controller front panel with the hex socket screws.
3.
Attach the ExpressCard cable.
4.
Attach and tighten the clamping bracket with the thumb nuts.
5.
With the security bracket in its rightmost position, tighten the hex
socket screws with the hex key.
Figure 2.
Securing Both an ExpressCard and ExpressCard Cable
1
ExpressCard Cable
2
Thumb Nut (2x)
3
Clamping Bracket
4
Sliding Bracket
5
Security Bracket
6
Hex Socket Screw (2x)
RESET
10/1
00/1
000
ACT/LINK
TRIG
DRIVE
PWR OK
1
3
4
5
6
2
