8
|
ni.com
|
CompactRIO cRIO-9066/cRIO-9067 Operating Instructions
Mounting the Chassis Using the NI Panel Mounting Kit
You can use the NI panel mounting kit, part number 782863-01, to mount the chassis on a flat
surface. Ensure there is sufficient surface area prior to mounting by referring to the dimensions
shown in Figure 7.
Figure 7.
Dimensions of cRIO-906
x
with Panel Mounting Plate Installed
Complete the following steps to mount the chassis using the mounting kit.
1.
Fasten the panel mounting plate to the chassis using a number 2 Phillips screwdriver and
three M4
×
23 screws, as shown in Figure 8. National Instruments provides these screws
with the panel mounting kit. You
must
use these screws because they are the correct depth
and thread for the panel mounting plate. Tighten the screws to a maximum torque of
1.3 N · m (11.5 lb · in.).
Figure 8.
Installing the Panel Mounting Plate on the cRIO-906
x
2.
Fasten the panel mounting plate to the surface using the screwdriver and screws that are
appropriate for the surface. The maximum screw size is M5 or number 10.
3
55.6 mm
(14.00 in.)
33
6.5 mm
(1
3
.25 in.)
9.5 mm
(0.
38
in.)
17.6 mm
(0.69 in.)
88
.1 mm
(
3
.47 in.)
3
1.7 mm
(1.25 in.)
6
3
.5 mm
(2.50 in.)
7.2 mm
(0.29 in.)
