© National Instruments
|
5-9
Figure 5-10 shows an example of a sample clocked buffered pulse measurement.
Figure 5-10.
Sample Clocked Buffered Pulse Measurement
Note
If a pulse does not occur between sample clocks, an overrun error occurs.
For information about connecting counter signals, refer to the
section.
Semi-Period Measurement
In semi-period measurements, the counter measures a semi-period on its Gate input signal after
the counter is armed. A semi-period is the time between any two consecutive edges on the Gate
input.
You can route an internal or external periodic clock signal (with a known period) to the Source
input of the counter. The counter counts the number of rising (or falling) edges occurring on the
Source input between two edges of the Gate signal.
You can calculate the semi-period of the Gate input by multiplying the period of the Source
signal by the number of edges returned by the counter.
Refer to the following sections for more information about semi-period measurement options:
•
Single Semi-Period Measurement
•
Implicit Buffered Semi-Period Measurement
Refer to the
Pulse versus Semi-Period Measurements
section for information about the
differences between semi-period measurement and pulse measurement.
Single Semi-Period Measurement
Single semi-period measurement is equivalent to single pulse-width measurement.
Co
u
nter
Armed
G
a
te
S
o
u
rce
H L
2 2
H L
2 2
3 3
Sa
mple
Clock
S
1
S
2
B
u
ffer
2
2
3
3
Summary of Contents for cDAQ-9179
Page 1: ...cDAQ 9179...
