Chapter 2 Installation and Verification
Serial for Windows NT
2-6
©
National Instruments Corporation
Figure 2-4. AT Serial Board Installation
5.
Screw the mounting bracket of the AT serial board to the back panel
rail of the computer.
6.
Replace the cover, and turn on your computer.
7.
Windows NT displays one or more New Hardware Found dialog
boxes, depending on your serial hardware. In each dialog box, make
sure that Windows Default Driver is selected, and click on OK.
8.
The serial configuration software displays a PnP Port
Configuration dialog box. Select a nonconflicting base I/O address
and IRQ setting for the port/card, and click on OK. For more
information on selecting resources for your post/card, refer to the
Resource Settings section of Chapter 3, Configuration.
9.
After you have selected the resources for all ports, choose to restart
the computer when the system prompts you.
Your serial hardware is now installed.
