22 / 48
5. Press the MODE button to confirm and switch to the next setting.
6. Sequence of the settings: Hours > minutes
7. Finally, press the MODE button to save the settings and exit settings mode.
8. To activate the alarm, press the ALARM button until the corresponding alarm symbol (alarm clock)
for AL1, AL2 or AL1+AL2 is displayed.
9. To deactivate the alarm, press the ALARM button repeatedly until the alarm symbol (bell) is no
longer displayed.
13 Snooze function
1. When the alarm sounds, press the SNZ/LIGHT button to activate the snooze function. The alarm
sounds again after 5 minutes.
2. When the alarm sounds, press any other key to stop the alarm until the set alarm time is reached
again.
3. If no key is pressed, the alarm is automatically switched off after 2 minutes.
Set the snooze time
4. In normal display mode, press the SNZ/LIGHT button for about 3 seconds to enter the snooze time
setting mode.
5. The snooze time can be set from 3 to a maximum of 20 minutes.
6. Press UP or DOWN button to change the value.
7. Finally, press the MODE button to save the settings and exit settings mode.
14 Temperature alarm setting
1. Press the CHANNEL button on the base station repeatedly to select the desired outdoor sensor.
2. Press and hold the ALERT button for about 3 seconds in the normal time display mode to enter
the temperature alarm setting mode.
3. Digits to be set are flashing.
4. Press UP or DOWN button to change the value.
5. Press the ALERT button to confirm and switch to the next setting.the next setting.
6. Sequence of the settings: Upper temperature limit outdoor (HIGH) > Lower temperature limit out-
door (LOW) > Upper temperature limit indoor (HIGH) > Lower temperature limit indoor (LOW) >
Exit
7. If no setting has been made after 30 seconds, the temperature setting mode is automatically
closed. The settings made up to that point are saved.
Activate/deactivate temperature alarm
8. Press the ALERT button repeatedly to display the selected temperature limits.
9. Press the UP or DOWN button to enable or disable the alarm for the currently selected temperat-
ure limit.
10. When the outdoor temperature reaches one of the limits, the temperature alarm symbol flashes
and a warning tone sounds for about 5 seconds. This is repeated every 1 minute until the temper-
ature falls below the limit value again.
11. When the alarm sounds, press any button to stop the alarm.
