To SYNC the drone start by standing DIRECTLY
BEHIND the drone. Turn on the remote control
by pushing the POWER button. The lights on the
bottom of the drone will briefly flash, indicating
the remote control is on and ready to sync. The
SYNCED light on the remote control will also
flash, confirming it’s ready to sync.
Step 2
SYNC FROM DIRECTLY
BEHIND THE DRONE
throttle lever down, and the sync will be complete. The lights on the bottom of the
drone will now flash slowly, and the SYNCED light on the remote control will be
constantly illuminated (no longer flashing), indicating you are ready for take-off!
Step 3
When ready to land the quadcopter, press the TAKE OFF & LAND button
again and the quadcopter will slowly descend to the ground and land.
NOTE: Do not try to catch the quadcopter as it lands. This could result in
damage to the quadcopter and injury to you.
Step 5
As the battery begins to run out of power the drone lights will flash rapidly,
indicating you should immediately land your drone. The drone will run out of
power approximately 10–20 seconds after the flashing warning lights start
blinking. The drone will then automatically land and the operator will NOT
have control over the drone or its descent once the battery is out of power. It
is always recommended that you immediately land the drone when the battery
is low to prevent damage to the drone.
NOTE: It’s highly recommended that pilot reduces the altitude of the drone
after approximately 7 minutes of flying time. This should allow for a safe and
controlled landing of the drone, before the battery is completely exhausted.
Step 6
With the quadcopter powered on and synced to the remote control, re-
confirm people and objects are at a safe distance away. Press the TAKE
OFF & LAND button. The quadcopter should immediately rise off the
ground and hover.
NOTE: Do not throw the quadcopter for take-off. It is always
recommended to start from the ground level a safe distance away
(approximately 10 feet from the drone).
Step 4
To sync, push up the throttle lever on the
remote control until the SYNCED light
flashes rapidly. Then immediately push the
LIGHTS
LIGHTS
TAKE OFF & LAND
POWER
SYNCED LIGHT
