National Cycle, Inc.
PO Box 158 Maywood, IL 60153-0158 USA P: 708-343-0400 / F: 708-343-0625 / E: [email protected]
www.nationalcycle.com
©2019 National Cycle, Inc.
Page 3 of 4
10-110804-000 11/19
Figure 9
Figure 10
Figure 12
Figure 13
INSTALLATION; CONT’D.
Figure 9
Now you will begin installation of the Gauge Cover/Visor (
C
).
Begin by removing the paper backing from the adhesive Velcro®
strips attached to the inside of the the Gauge Cover/Visor.
Figure 10
Now install the Gauge Cover/Visor (
C
) onto the bike’s Meter
Case Cover, with the bottom of the Visor flush with the bottom
leading edge of the Meter Case Cover.
Figure 11
Press firmly at the Velcro® attachment points to get a good
Hook/Loop connection and to firmly adhere the adhesive back-
ing of the Velcro® strips to both the Gauge Cover/Visor and the
bike’s Meter Case Cover.
Figure 12
With a 4mm Allen Wrench in hand, and the four 5x16 Bolts and
Nylon Washers removed at the start of
PREPARATION
, position
your new Windscreen (
A
) onto the
Mounting Bracket (
B
).
Figure 12
Install the Bolts/Washers through the Windscreen and into the
5mm Wellnuts in the Bracket. It may help to reach a finger
behind the Bracket to hold each Wellnut in place as you thread
the Bolt into it.
Install each 5x16 Bolt just finger-tight until all four are in place.
Then tighten all four securely.
Now go out and enjoy the ride!
C
A
Figure 11
C
