Page 6
National Communications
INSTALLATION
Where an existing RADIO, CD or TAPE player
is being replaced with a DMC FLASH
Existing on Hold users can install this unit themselves by simply plugging
DMC in place of the existing Audio source.
Where a Radio or Message On Hold facility has not been used
previously, technical installation will be required (see page 7).
The contact details of a suitable Installation Technician in your area
can be provided.
Where an existing RADIO, CD or TAPE player
is being replaced with DMC4
1.
Unplug POWER to the existing audio device.
2.
DISCONNECT the AUDIO OUTPUT cord from the existing audio
device. This cord connects from the AUX or HEADPHONE outlet
from your existing device through to a Line Isolation Transformer
(LIU) which is connected to your telephone system.
3.
CONNECT this AUDIO OUTPUT cord to the AUDIO OUTPUT port
of your DMC device. This cord connects to a Line Isolation
Transformer (LIU) which is connected to your telephone system.
4.
CONNECT the supplied POWER ADAPTOR to your DMC
Device, and switch your power ON.
5. Call your telephone line and have someone place your call ON
HOLD.
Adjust the OUTPUT VOLUME from your DMC device, using the
VOLUME ADJUST knob located on the bottom of your unit, until
the ON HOLD volume is set to your desired level.
