Installation Manual:
1. Install two synchronous belts as shown in the figure. First
tighten one end with a T-nut, then pass the other end
through the roller on the X-axis assembly as shown in the
figure, and finally tighten the other end and fix it with a T-
nut.
2. T-nut fixing method (Push the T-nut from the groove on
the end of the profile, and then use the screw to tighten
the T-nut), the T-nut is as close to the end of the profile as
possible, and cut off the excess belt.
3. Cover the profile end cover (the side of the end cap with
protrusions is facing down)
TIPS:
The installation of the Y-axis synchronous belt can refer to
the installed synchronous belt on the X-axis
assembly.Determine whether the timing belt is tight
enough: press the position shown in Figure 4 with your
fingers, and if there is no obvious deformation, it is tight
enough. If the deformation is large, loosen one end of the
T-nut and tighten the timing belt, and then tighten the T-
nut.
1
3
3
3
3
Type T Nut *4
Type T Nut Lock
screws*4
2
Profile end cover *4
Synchronous belt *2
Step3 Required components:
4
Tighten the T nut
and cut off the
excess belt.
5
S t e p 3
