SIREN R3 USER MANUAL
P6
3.
You can then go back into pairing mode by pressing Power
and Volume together until you hear a single bleep and the first
LED lights. Now pair your heads accordingly.
NOTE:
When in pairing mode, if no signal from an R3 head is
registered within 10 seconds the R3 handset returns to normal
operation.
Operating Frequency:
Within the 868MHz
European Licence Exempt Band.
Ambient operating temperature of +40C -10C.
Protect against water ingress, do not immerse.
Thank you for purchasing your Siren R3 bite alarms & Receiver.
We never forget our customers’ support.
Fitting Nash Bobbin Glow Pipes to Siren R3s:
1.
Remove the Glow Pipe from the blister pack. Do NOT remove
or discard the soft moulded diffuser at one end.
2.
Remove the rubber grommet from the direct connection
socket at the front of the R3 alarm.
3.
Push the end of the Glow Pipe that does not have the soft
moulded diffuser into the R3’s direct connection socket, and
carefully screw into the thread. The end of the Glow Pipe must
be touching the LED inside the R3.
4.
Your Nash Bobbin Head can now be screwed on to the end of
the Glow Pipe that has the soft moulded diffuser.
Fitting Drag Weights to Nash Bobbin Glow Pipes:
1.
Temporarily remove the moulded diffuser from the end of
the Glow Pipe.
2.
Loosen the two sections of threaded collar at the same end
of the Glow Pipe by unscrewing two complete turns.
3.
Push the collar down the Glow Pipe by 7mm to make room
2020 SIREN R3 USER MANUAL 25.02.20.indd 6
13/07/2020 08:41
