20
2 . Attach this end of the
pressure line to the
female luer fitting
assembled at the top of
the electronic control
unit marked CUFF . (See
Figure 53) .
3 . Locate the cable that
extends from the blood
pressure simulator
arm and plug into the
top of the Electronic
Control Unit using the
jack labeled ARM . (See
Figure 54) .
At this point, the blood
pressure simulator is ready
for use . The unit has been
factory calibrated for use
with accessories included . No further calibration
adjustments are necessary at this time . If the unit is
to be used with a sphygmomanometer other than
the one supplied, or when recalibration is necessary,
see the section titled Calibration Procedures .
Electronic Control Unit
Function
1 . Press the power
button on the top
right of the unit . (See
Figure 55) . Observe the
display and verify that
a readable display is
present .
Note: The control box has a battery saving feature
that will turn the unit off after approximately 8-10
minutes if no keys are used within that period of time .
2 . Under the display window are three buttons:
Menu, Gap, and Calibrate .
Blood Pressure Arm
Features included with LF04301,
LF04302, and LF04302EX .
Installing the Batteries
1 . Take the Blood Pressure
Electronic Control Unit out
of the box and turn it over,
placing it face down onto
a padded work surface . Locate the “Open”
compartment on the back of the panel
where the batteries are to be installed . Place
your thumb or index finger on the “Open”
compartment and push up . (See Figure 51) .
2 . Install 6 “AA” batteries as indicated by the
orientation diagram embossed in the bottom
of the bracket . After the batteries have been
properly installed, reassemble the Electronic
Control Unit by reversing the disassembly
procedures .
Turning the Electronic Control Unit On
1 . Place the unit face up
on the padded work
surface .
2 . Press the power button
on the top right of the
unit . (See Figure 52) .
3 . Observe the display
and verify that a
readable display is
present .
Connecting the Arm, Electronic Control Unit, and
Sphygmomanometer
1 . Locate the end of the pressure line attached to
the sphygmomanometer that is assembled with
a male luer fitting .
Set Up
Blood Pressure Arm
Fig 53.
Fig 54.
Fig 55.
Fig 52.
Power
Button
Fig 51.
Summary of Contents for TERi LF04302EX
Page 39: ...YEARS 5 Up to 5 years warranty...
