NASA electric NS-9097, User Manual

Page: 14 / 21

7
formance, please check the engine protec -
tion filter and air outlet filter after each bag
change and clean if necessary.
• The lid of the appliance will not close with -
out putting the dust bag in place, please do
not push the lid and put the bag in place, then
close the lid.
Alert!
It is recommended that you do not turn on the
vacuum cleaner at peak hours of power con -
sumption, such as at the beginning of the night,
regardless of the double costs of these hours,
fluctuations in electricity will damage to the
electrical systems of the device, especially the
motor and the board; Therefore, it is strongly
recommended that you do as much cleaning as
possible in the morning, evening or at midnight.
Replacing & cleaning the HEPA filter
guide
1. Press Slide the filter lid to open the “HEPA”
filter lid.
2.
Press the clamps on the filter cover to
the bottom, to open the “HEPA” filter lid. )As
shown in Figure 4-1(
*
Unplug the air output filter from the filter
cover and waste if necessary. )As shown in
Figure 4-2(
*
Remove the “HEPA“ filter and waste it.
3.
Put the filters in place. )As shown in Figures
4-3,4-4(
• Clean the “HEPA” filter every 3 months, with
a waste, this will increase the life span of the
motor and prevent the exhaust of air con -
taminated inside the environment.
• Wash the air outlet filter and dry it com -
pletely, so that its moisture is destroyed, then
put it inside the HEPA filter lid.
• Avoid turning off the device without filter.
• Do not use it in the event of a failure and
the filter tear and replace it. New filter can
be provided from NASA Electric after-sales
service centers. )Please call +982145114.(
Motor Filter Cleaning Guide
1.
Turn off the appliance and unplug it.
2.
Unlock the tank door by pulling the lid lock
upwards.
3.
Remove the dust bag to access the motor
protection filter.
4.
Remove the motor protection filter holder
by pressing the clamp.
5.
Remove the motor protection filter from
the motor protection filter holder. )as shown
in Figure 5-1(
6.
Rinse the filter with cold water and allow
to dry.
7.
Insert the filter into the motor protection
filter holder.
• Do not turn on the vacuum cleaner without a
filter. Otherwise, the motor will be damaged
and the suction power will be reduced.
• Do not insert the wet filter into the device
under any circumstances.
• Obtain filters from certified NASA Electric
after-sales service centers.
3-1
4-1 4-2
4-3
5-1