NARDA FieldMan, User Manual

Page: 111 / 126

Narda FieldMan
111
11.1.3 Establishing an optical connection
11.2 Firmware update
The firmware update of the Narda FieldMan is performed using the Narda-TSX PC soft-
ware.
⇒
The description of how to perform the firmware update can be found in the online help
for the Narda-TSX PC software.
In principle, an optical connection can also be established with a PC and the PC software
can be used via this connection. However, due to the higher transmission speed, a USB
or Ethernet connection is much better suited for this purpose. However, for remote mea-
surements with HF probes, the optical connection via fiber optic cable and optical-electri-
cal converter to USB is the best solution, because in this way interference is avoided.
Establish an optical connection:
1.
Under
GENERAL SETTINGS
>
CONNECTIVITY
>
OPTICAL INTERFACE
, select
the
Remote
function.
2.
Connect the device at the optical connector (see
Fig. 2: 7
) to a PC via the optical
cable.
↳
The first time the device is connected, it is automatically set up on the PC.
↳
After the setup, the device can be used.
3.
For information on remote control of the device, refer to the online help for the Narda-
TSX PC software.