Napoleon ultra chef L485, User Manual

Page: 13 / 69

EN
13
www.napoleongrills.com
Tube Burner : The burners are made from heavy wall 304 stainless steel, but extreme heat and a corrosive
envi ronment can cause surface corrosion to occur. This can be removed with a brass wire brush.
CAUTION!
Beware of Spiders.
Spiders and insects are attracted to the smell of propane and natural gas. The burner is equipped with
an in sect screen on the air shutter, which reduces the likelihood of insects building nests inside the burner
but does not entirely eliminate the problem. A nest or web can cause the burner to burn with a soft yellow
or orange flame or cause a fire (flashback) at the air shutter beneath the control panel. To clean the inside
of the burner, it must be removed from the gas grill: Remove the screw that attaches the burner to the
back wall. Slide the burner back and upwards to remove. Cleaning: Use a flexible venturi tube brush
to clean the inside of the burner. Shake any loose debris from the burner through the gas inlet. Check
the burner ports and valve orifices for blockages. Burner ports can close over time due to cooking debris and
corrosion, use an opened pa perclip or the supplied port maintenance bit to clean them. Drill out blocked ports
using this drill bit in a small cordless drill. The ports are easier to clean if the burner is removed from the
grill, but it can also be done with the burner installed. Do not flex the drill bit when drilling the ports, as
this will cause the drill bit to break. This drill is for burner ports only, not for the brass orifices (jets) which
regulate the flow into the burner. Take care not to enlarge the holes. Ensure the insect screen is clean,
tight, and free of any lint or other debris.
Reinstallation :
Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing.
WARNING!
When reinstalling the burner after cleaning
it is very important that the valve/orifice enters the burner
tube before lighting your gas grill. If the valve is not inside the
burner tube a fire or explosion could occur.
Aluminum Castings : Clean castings periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidation to occur on aluminum surfaces. This appears as white
spots on the castings. To refinish these areas, clean first and sand lightly with fine sandpaper. Wipe the
surface to remove any residue and paint with high temperature barbecue paint. Protect surrounding areas
from over- spray. Follow the manufacture’s directions for curing.