10
OPERATION
OPERATION
If you experience any ignition problem, turn off the heater and gas
supply, and consult "Troubleshooting" on page 14.
Lighting Instruction
1. Turn control knob clockwise to "OFF" position.
2. Open base assembly door.
3. Turn gas supply "ON" by connecting propane cylinder to regulator inlet.
Check for leaks by applying soap solution to cylinder and
regulator connection.
4. Push in gas control knob slightly and turn counterclockwise to "IGN/ON".
This will light the burner. If needed, keep depressing and turn control knob
counterclockwise until the burner lights.
5. keep the control knob depressed or at least 30 seconds after lighting
burner. After 30 seconds release the control knob.
6. If burner does no stay lit, repeat steps 4 & 5.
7. When burner is lit, turn gas control knob counterclockwise to
desired higher setting.
8. Close base assembly door.
This product is equipped with ODS (Oxygen Deprivation System)
Before Turning Gas Supply ON
Your heater was designed and approved for OUTDOOR USE ONLY. Do NOT
use it inside a building ,or any other enclosed area.
Make sure surrounding areas are free of combustible materials, gasoline
and other flammable vapors or liquids.
Ensure that there is no obstruction to air ventilation.
Be sure all gas connections are tight and there are no leaks.
Be sure the access panel is clear of debris.
Be sure any component removed during assembly or servicing is replaced
and fastened prior to starting.
Before Lighting
Heater should be thoroughly inspected before each use, and by a qualified
service person at least annually.
If relighting a hot heater, always wait at least 5 minutes.
Our heater is tested for quality assurance.
Ignition attempts should succeed 8 out of 10 attempts.
FOR YOUR SAFETY:
If at any time you are unable to light burner
and smell gas, wait 5 minutes to allow gas
to dissipate before attempting to light
heater. If, after 1 minute, you are unable to
light burner, wait 5 minutes and allow
flammable vapors to dissipate before
attempting to light heater again.
WA R N I N G
FOR YOUR SAFETY:
DO NOT
touch or move heater for
at least 45 minutes after use.
Allow emitter and dome to cool before
touching.
WA R N I N G
Note:
The flame pattern at the emitter grid should be
visually checked
whenever heater is operated. Normally the burner flame is blue, but little
yellow flame is acceptable.
If flames extend beyond surface of the emitter grid , or the phenomena of
flame lift or light back, or black spot is accumulating on the emitter grid or
reflector, the heater should be turned off immediately. The heater should not
be operated again until the unit is serviced and or repaired.
WARNING: DO NOT attempt to operate heater until you have read and
understand all precautions. Failure to do so can result in serious
personal injury, death or property damage.
N
O
/
N
G
I
W
O
L
H
GI
H
OFF
P
u
sh
to
tu
rn
N
O
/
N
G
I
W
O
L
H
GI
H
OFF
P
u
sh
to
tu
rn