Napoleon LE485, Instruction Manual

Page: 4 / 68

www.napoleongrills.com
4
EN
Correct Disposal Of This Product
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
Electrical Precautions
WARNING!
Failure to follow these instructions could result in property damage, personal injury or
death.
• 230V - 50HZ -.09A -20W – type 2 transformer (Electrical Rating - Internal Light Models Only).
• To protect against electric shock, do not immerse cord or plugs in water or other liquid.
• Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or
taking off parts.
• Do not operate any outdoor cooking gas appliance with a damaged cord, plug, or after the
appliance malfunctions or has been damaged in any manner. Contact the manufacturer for repair.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
• Do not let the cord hang over the edge of a table or touch hot surfaces.
• Do not use an outdoor cooking gas appliance for purposes other than intended.
• When connecting, first connect plug to the outdoor cooking gas appliance then plug appliance into
the outlet.
• Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance.
•
Never remove the grounding plug or use with an adapter of 2 prongs.
• Use only extension cords with a 3 prong grounding plug, rated for the power of the equipment,
and approved for outdoor use with a W-A marking.
Gas Cylinder
Use only gas cylinders, which meet national and regional codes. The minimum cylinder size for butane
units is 13kg, and for propane units is 6kg. Ensure that the cylinder can provide enough fuel to operate the
appliance. If in doubt, check with your local gas supplier.
• Use caution when handling the cylinder valve.
• Never connect a cylinder, which does not meet local codes.
All cylinders 7kg or larger must be placed outside the enclosure (under the right side shelf) on level
ground. Cylinders smaller than 7kg (maximum size 465mm high by 306mm wide) may be placed inside the
enclosure, on the right side of the bottom shelf. Only cylinders connected to the appliance may be stored
in the enclosure, or close to the appliance. Spare cylinders must not be stored in the enclosure, or in close
proximity of an operating unit. Cylinders must not be exposed to extreme heat or direct sunlight.
WARNING!
Ensure that the hose is routed to maintain proper clearance to the underside of the
unit. Hoses that contact high temperature surfaces may melt and leak, causing a fire.
Cylinder Connection : Ensure that the gas regulator hose is kink free. Remove the cap or plug from the
cylinder fuel valve. Tighten regulator to cylinder valve.
Leak test all joints prior to using the barbecue.
A
leak test must be performed annually, and each time a cylinder is hooked up, or if a part of the gas system
is replaced.
WARNING!
• Do not route hose underneath drip pan.
• Do not route hose between space in bottom shelf and back panel.
• Do not route hose over top of back panel.
• Ensure all connections are tightened using two wrenches. Do not use Teflon tape or pipe dope on
any hose connection.
• Ensure the hose does not contact any high temperature surfaces, or it may melt and leak causing a
fire.
• Do not use enclosure to store excess hose, as there is a greater chance of the hose contacting a hot
surface, it may melt and leak causing a fire.