Napoleon HDX52NT-2, Installation And Operating Instructions Manual, Page: 46 / 132

46
W415-2180 / A / 11.28.16
EN
Once the appliance has been framed and fi nished, control access can only be achieved by removing the
access panel from the inside right side of the fi rebox. The following sub sections take you through the steps
of accessing the control as if the appliance is installed.
*Prior to removing the control panel follow the “DOOR REMOVAL” process and then follow the media removal
instructions located under the “MAINTENANCE” section.
NOTE: IT WILL BE NECESSARY TO REPLACE THE GASKET (W290-0238) FOR THE ACCESS PLATE IF
THE APPLIANCE HAS BEEN PREVIOUSLY OPERATED BEFORE REMOVING THE PLATE (W290-0238).
A. Remove the media from the appliance, follow removal instructions under the “ MEDIA REMOVAL”
section.
B. Remove the right side brick / porcelain panel, follow removal instructions under the “ BRICK /
PORCELAIN PANEL REMOVAL” section.
C. To remove the glass media trays to remove the glass burner, follow removal instructions under the
“MEDIA TRAY” section (glass burner only).
D. Remove the grate before removing the brick / porcelain panels, follow removal instructions under the
“GRATE REMOVAL” section (log burner only).
E. To access the controls remove the 8 screws securing the access plate from inside the fi rebox.
F. Care should be taken to ensure avoiding damage to the gasket.
G. Reverse this process to install the control access. Ensure the access plate is well sealed to the
fi replace.
RIGHT
SIDE
POST INST
ALLA
TION ACCESS
PRE INSTALLATION
ACCESS
10.2 CONTROL ACCESS