Napoleon GD16 - N, Installation And Operation Instructions Manual, Page: 15 / 24

15
WS-415-112 / 06.18.99
FINISHING
DOOR, LOUVRE AND TRIM REMOV DOOR, LOUVRE AND TRIM REMOV
DOOR, LOUVRE AND TRIM REMOV DOOR, LOUVRE AND TRIM REMOV DOOR, LOUVRE AND TRIM REMOVAL & INST
AL & INST
AL & INST AL & INST AL & INSTALLA
ALLA
ALLA ALLA ALLATION
TION
TION TION TION
ENSURE THAT THE DOOR IS PROPERLY CLIPPED ONTO THE STEEL LIP TO PREVENT
OVERHEATING, GLASS BREAKAGE AND/OR DISCOLOURATION OF THE UPPER TRIM.
Both top and bottom door trim must be removed prior to
door removal. Lift up the top trim and unhook from the door.
The bottom trim, held on with magnets, may be pulled off
and lifted out of the bottom door sill.
FIGURE 29.
Remove the five screws securing the sides and bottom of the door. Lift up and out. To re-install, repeat in reverse order.
Retighten screws snugly. DO NOT OVER-TIGHTEN.
The top and bottom door trim may be installed next. Lift up the top trim and hook over the top of the door. The bottom trim
is inserted into the bottom door sill. Push in to engage the magnets. The louvre assemblies are installed as illustrated
in
FIGURE 29 . Optional plated door trim, door side trim and arched door facias are available at your local Napoleon / Wolf
Steel dealer.
LOG PLACEMENT LOG PLACEMENT
LOG PLACEMENT LOG PLACEMENT LOG PLACEMENT
PHAZER
TM
logs exclusive to Napo-
leon Fireplaces, provide a unique and
realistic glowing effect that is different
in every installation.
POSITIONING THE LOGS IMPROP-
ERLY WILL CAUSE FLAME IMPINGE-
MENT AND CARBONING.
Position the logs as shown.
Place the back log onto the log sup-
port bracket, located on the rear wall
of the combustion chamber, pushing
it as close to the firebox wall as pos-
sible.
Center the front log behind the two lo-
cating tabs and along the inside front
edge of the burner tray.
Set the two smaller logs into the pockets and grooves of the front and back logs, respectively.
Log colours may vary. During the initial use of the fireplace, the colours will become more uniform as colour pigments
burn in during the heat activated curing process. Blocked burner ports can cause an incorrect flame pattern, carbon
deposits and delayed ignition.
PHAZER
TM
logs glow when exposed to direct flame. Use only certified PHAZER
TM
logs
available from your Napoleon / Wolf Steel Ltd. dealer.
FIGURES 28
FIGURE 27
FIGURE 29b
FIGURE29c
FIGURE 29a
DOOR
STEEL LIP
FIGURE 26