Napoleon BIM485, Instructions Manual

Page: 7 / 56

www.napoleongrills.com
7
EN
Lighting Hole
Off Position
WARNING!
Open lid.
WARNING!
Ensure all burner controls are in the off position. Turn on the gas supply valve.
Main Tube Burner Lighting Rear Burner Lighting
(Rotisserie Burner)
(if equipped)
Side Burner Lighting
(If equipped)
1. Open grill lid. 1. Open grill lid. 1. Open side burner cover.
2. Push and turn any main burner knob
slowly to the ’hi’ position. This action
will ignite the pilot flame which will in
turn light the selected burner. If the
pilot lights, continue to push down on
the control knob until the burner lights
and then release.
2. Remove the warming rack. 2. Push and turn side burner control to high
position.
3. If the pilot does not ignite, then
immediately turn the control knob back
to the ‘off position and repeat step 2
several times.
3. Push and turn the rotisserie burner control
knob slowly to the ‘hi’ position. This action
will ignite the pilot flame which will in turn
light the burner. If the pilot lights, continue
to push down on the burner control knob
until the burner lights then release.
3. Press and hold igniter button until burner
lights, or light by match.
4. If the pilot and burner will not ignite
within 5 seconds, turn the control knob
to the ‘off’ position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.
4. If the burner does not ignite, then
immediately turn the control knob back to
the ‘off’ position and repeat step 3 several
times.
4. If the burner will not ignite within 5
seconds, turn the control knob to the ‘off’
position and wait 5 minutes for any excess gas
to dissipate. Either repeat steps 2 and 3 or
light with a match.
5. If lighting the unit with a match, clip
the match into the supplied lighting
rod. Hold the lit match down through
the grill and sear plate while turning the
corresponding burner valve to high.
5. If the burner will not ignite within 5
seconds, turn the control knob to the ‘off’
position and wait 5 minutes for any excess
gas to dissipate. Either repeat steps 3 and 4
or light with a match.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
Do not use the rear burner (rotisserie burner) with the main burners operating.
Lighting Instructions
Left
Burner
Right
Burner
Centre
Burner
Lights