A.
Connect the gas flex lines and the pilot line
to the gas bulkheads located under the valve
access opening. Be sure to match up the gas
manifold marked with a painted dot with the
center bulkhead, also marked with a painted
dot. Care must be taken to ensure the pilot
line isn’t damaged and ensuring gas tight
connections are made.
Gas
Bulkheads
Painted
Dots
Pilot
Bulkhead
Pilot
Electrode
Leads
Pilot
Electrode
2.3 bulkheads
See Thru
Window
Orifice
Venturi
Tube
B.
Connect the pilot electrode leads to the
bulkhead matching the 1/4” flag with the 1/4”
bulkhead spade and the 3/16” flag with the
3/16” spade.
C.
Ensure the 2 venturi tubes are over the orifices
before lighting.
D.
Check for gas leaks by brushing on a soap
and water solution. Do not use open flame.
E.
After leak test has been performed reinstall
access panel with gasket.
2.4 night light™ installation
The HD81-1 comes equipped with two “Night Lights™”. The lights have been pre-wired and are controlled from
the remote control.
If in the event the lamps or lens need replacing, follow the instructions below:
A.
Shut off breaker at main power supply
B.
Remove the four screws that secure the lens frame to the firebox sides. This frame retains the glass lens.
C.
The lamp can now be accessed.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as lamp and lens are special “high
temperature” products. When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens. “Light Leakage” from the holes in the housing lamp may be
observed. The holes in the lamp housing are necessary for ventilation and must not be covered.
GASKET
LENS
FRAME
COLOURED SIDE UP
JOINT
D’ÉTANCHÉITÉ
LENTILLE
CADRE
CÔTÉ COLORÉ
AU-DESSUS
NIGHT LIGHTS
Bulkhead covers need to be removed.
note:
Do not handle the lamp (bulb) with bare fingers, protect with a clean, dry cloth.
note:
EN
W415-0713 / E / 05.10.18
3
installation
