45
EN
W415-1293 / C / 07.28.16
6.3 LOG
PLACEMENT
PHAZER
TM
logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours
may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
!
WARNING
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
76.1A
C.
Place the right log (W135-0545) onto the two
studs located on the right side of the log
support.
D.
Place the left crossover log (W135-0546) onto
the pin located in the left side of the rear log,
allow it to rest in the notch of the left log.
B
A
C
B
A
C
D
A.
Place the rear log (W135-0620) fi rmly onto the
two studs located at the rear of the support
tray. Ensure the log sits fl at and does not
cover the pilot opening. Place two pins in
holes located on the top of the rear log.
B.
Place the left log (W135-0544) onto the two
studs located on the left side of the log support.
B
A
A
PIN
PIN
PINS
E.
Place the right crossover log (W135-0547)
onto the pin located in the right side of the
rear log, allow it to rest in the notch of the
right log.
F.
Reinstall the door and safety screen, refer to
the video tutorial or your installation manual
for installation instructions.
B
A
C
D
E
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of
the small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed
edges of the fi bre hairs will glow.
The ember material will only glow when exposed to direct fl ame;
however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition.
PHAZER
TM
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and
PHAZER
TM
logs available
from your authorized dealer / distributor.
6.4 GLOWING
EMBERS