SETTING UP THE SCREEN ROOM
9.
Slide the long fiberglass pole through the sleeve located at
the top of the screen room. Insert either end into the starred
(small) end of the pole joint attached to the top corner of the
screen room.
2016 Napier Outdoors
Rev. 05 12.01.15
4 of 10
11. Stake the screen room and tent to the ground through the
corner and side webbing loops.
SETTING UP THE RAINFLY & AWNING
12. Drape the rainfly over the tent. Locate the rainfly side that
says “Vehicle Side” and place towards the vehicle. Hook the
rainfly to the bottom female clips and tighten the straps.
Secure the velcro tabs located on the inside of the rainfly to
the poles.
10. Insert the steel tent pole into the opposite end of the pole
joint located at the top of the screen room. Insert the opposite
end of the pole into the grommet hole located at the corner
of the tent (where the tent steel pole is located). Repeat on
the other side of the screen room.
11. Stake out the rainfly guide ropes on each corner of the tent
to the ground.
14. Assemble the awning poles (2) by unfolding each section.
Place the pointed end of the pole through the grommet at the
corner of the awning. Insert the ring on the guide rope around
the point and place the awning cap over the guide rope.
Stake the pole to the ground and adjust the length of the
guide rope. Repeat on the other side.
