ATTACHING TO YOUR TRUCK TENT
6.
From inside the ground tent, unzip the door and mesh that
faces the truck tent opening. Roll up the mesh and door and
secure with the T-straps.
A. Move the tent towards the truck tent. Slip the sleeve under
the bumper and over the truck tent’s entrance. Ensure the
sleeve is over the vestibule pole
3 of 7
B. Attach the bottom outside J-Hook strap to any part of the
wheel well and tighten the strap. Repeat on the opposite side
C. Hook the top outside straps with the pole clip to the
corner-to-corner pole on the truck tent. Repeat on the
opposite side
D. Ensure the exhaust pipe is outside the sleeve
WARNING: Carbon Monoxide gas is dangerous and can cause
unconsciousness or death. Never start or run the vehicle’s
engine when the tent is attached to the vehicle.
SETTING UP THE RAINFLY & AWNING
8. Drape the rainfly over the tent. Locate the rainfly side that
says “Truck Tent Side” and place towards the truck. Hook the
rainfly to the bottom female clips and tighten the straps.
Secure the velcro tabs located on the inside of the rainfly to
the poles.
9. A. Slide the pole through the sleeve located above the rainfly
door area. Place both ends into the grommet hole at each
corner of the rainfly
SETTING UP THE GEAR LOFT
10. To install the gear loft, place each corner hook of the gear
loft into the loop located on the ceiling of the tent.
7.
Stake the tent to the ground through the corner webbing loops
and the webbing loops by the main entrance door.
B. Stake out the rainfly bungee cords, at the side of the tent,
to the ground
